LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Oil Feed Pipes Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Refer to Battery Disconnect Warning
  1. Disconnect the negative battery cable.
  2. Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the transmission oil pan. Refer to Oil Pan Replacement .
  4. Remove the transmission oil filter assembly. Refer to Automatic Transmission Fluid Filter and Seal Replacement .
    5. Fig 1: View Of Oil Feed Pipe Bolts
    GM104550Courtesy of GENERAL MOTORS CORP.
  5. Remove the oil feed pipe bolts.
  6. Inspect the eight oil feed pipe seal rings.
  7. Replace the seal rings only if the seal rings are cut, swollen or damaged.
    8. Fig 2: Identifying Lo & Reverse Band Oil Pipe Assembly Seals
    GM104551Courtesy of GENERAL MOTORS CORP.
  8. Remove the low/reverse band oil pipe assembly.
  9. Remove the eight low/reverse band oil pipe assembly seals.
  10. Inspect the oil feed pipes for plugged passages, bent pipes, or cracks.
  11. Inspect the oil feed pipe seal rings. Verify the proper location of the seal rings. Replace the seal rings if these are cut, swelled or damaged.
scientia non olet · About LEMON Manuals