LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal and Output Shaft Sleeve Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of J 41228
    GM104568Courtesy of GENERAL MOTORS CORP.
    NOTE: J 41228  must be used in order to install the sleeve to the correct depth. See Special Tools .
  1. Use J 41228  to install a NEW sleeve on the output axle shaft. See Special Tools .
  2. Install the collet into the output shaft snap ring groove with the collet attached to the threaded collet shaft.
  3. Place the NEW sleeve over the collet.
  4. Install the bearing and nut onto the threaded collet shaft.
  5. Hold the collet shaft while tightening the nut in order to press the sleeve onto the output shaft.
  6. Remove the J 41228  . See Special Tools .
    7. Fig 2: Identifying Stub Axle Shaft Snap Rings
    GM1873867Courtesy of GENERAL MOTORS CORP.
  7. Install two NEW snap rings on the stub shaft.
  8. Apply grease to the output shaft splines.
    9. Fig 3: Identifying Stub Axle Shaft Seal & Installation Tools
    GM1875846Courtesy of GENERAL MOTORS CORP.
    NOTE: J 41102-1A  must be used in order to install the axle seal to the correct depth. See Special Tools .
  9. Install a NEW seal (1). Use the J 41102-1A  (3) with J 8092  (2). See Special Tools . Lubricate the seal lip with transmission fluid.
    10. Fig 4: View Of Stub Shaft
    GM104558Courtesy of GENERAL MOTORS CORP.
    NOTE: Carefully guide the axle shaft past the lip seal. Do not allow the shaft splines to contact any portion of the seal lip surface, otherwise damage to the seal will occur.
  10. Install the stub shaft into the transmission. Use a mallet to fully seat the shaft.
  11. Install the drive axle assembly. Refer to Wheel Drive Shaft Replacement .
  12. Lower the vehicle.
  13. Inspect the oil level. Refer to Transmission Fluid Level and Condition Check .
  14. Inspect the shaft and the seal for leaks.
scientia non olet · About LEMON Manuals