LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal and Output Shaft Sleeve Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left drive axle assembly. Refer to Wheel Drive Shaft Replacement .
    3. Fig 1: Locating Drive Axle Retaining Clip
    GM1873863Courtesy of GENERAL MOTORS CORP.
  3. Remove the snap ring from axle. Discard the snap ring. Do not reuse.
    4. Fig 2: View Of Case Cover Seal
    GM1873862Courtesy of GENERAL MOTORS CORP.
  4. Remove the output axle seal.
    5. Fig 3: Using Special Tool To Remove Sleeve From Output Axle Shaft
    GM569234Courtesy of GENERAL MOTORS CORP.
  5. Use the J 41227  to remove the sleeve from the output axle. See Special Tools .
scientia non olet · About LEMON Manuals