LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Floor Shift Control Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Shift Cable Retaining Nut
    GM1521636Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the shift cable retaining nut near the exhaust heat shield.
    3. Fig 2: Identifying Shift Cable
    GM1521639Courtesy of GENERAL MOTORS CORP.
  3. Remove the shift cable from the transmission cable bracket.
  4. Lower the vehicle.
  5. Disconnect the shift cable from the park/neutral position switch.
  6. Remove the console. Refer to Front Floor Console Replacement .
    7. Fig 3: View Of Shift Control
    GM851244Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the shift cable from the shift control assembly.
  8. Position the driver side front carpet aside.
    9. Fig 4: View Of Driver Floor Opening
    GM1740251Courtesy of GENERAL MOTORS CORP.
  9. Separate the grommet from the floor pan.
  10. Remove the cable from the vehicle by pulling the cable through the driver floor opening.
scientia non olet · About LEMON Manuals