Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Insert the cable through the driver floor opening.

Fig 1: View Of Driver Floor Opening

Courtesy of GENERAL MOTORS CORP.

Install the grommet flush with the floor opening.
Install the driver side front carpet.

Fig 2: View Of Shift Control

Courtesy of GENERAL MOTORS CORP.

Connect the shift cable to the shift control assembly.
Install the console. Refer to Front Floor Console Replacement .

Fig 3: Identifying Shift Cable

Courtesy of GENERAL MOTORS CORP.

Connect the shift cable to the park/neutral position switch.
Connect the shift cable to the transmission cable bracket.
Raise the vehicle.

Fig 4: Identifying Shift Cable Retaining Nut

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the shift cable retaining nut near the exhaust heat shield.
Tighten: Tighten the nut to 10 N.m (89 lb in).
Lower the vehicle.
Check the operation of the shift control cable for proper adjustment through all the gear ranges. If necessary refer to Shift Control Cable Adjustment .