LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Control Valve Body Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Air Cleaner Assembly
    GM13340Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner housing assembly. Refer to Air Cleaner Assembly Replacement .
    2. Fig 2: View Of Junction Block
    GM736049Courtesy of GENERAL MOTORS CORP.
  2. Remove the underhood electrical center from the bracket.
  3. Remove the underhood electrical center bracket.
    4. Fig 3: View Of Shift Cable & Shift Linkage
    GM494775Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the shift cable from the PNP switch.
  5. Remove the shift cable bracket.
    6. Fig 4: Removing/Installing Transaxle Range Switch Lever & Nut
    GM893829Courtesy of GENERAL MOTORS CORP.
  6. Remove the PNP switch lever nut and lever.
    7. Fig 5: Locating Transaxle Range Switch Bolts
    GM893832Courtesy of GENERAL MOTORS CORP.
  7. Remove the PNP switch. Refer to Park/Neutral Position Switch Replacement .
  8. Remove the transmission upper side cover bolts.
  9. Install the engine support fixture. Refer to Engine Support Fixture .
  10. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  11. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  12. Remove the left inner fender liner. Refer to Front Fender Liner Replacement .
  13. Remove the wheel drive shaft from the transmission. Refer to Wheel Drive Shaft Replacement .
  14. Remove the power steering gear mounting bolts. Refer to Steering Gear Replacement .
  15. Remove the frame. Refer to Frame Replacement .
  16. Remove the transmission mount. Refer to Transmission Front Mount Replacement  or Transmission Rear Mount Replacement .
  17. Lower the vehicle.
  18. Lower the engine with the engine support fixture.
  19. Raise the vehicle.
    20. Fig 6: View Of Case Side Cover Components
    GM55090Courtesy of GENERAL MOTORS CORP.
  20. Remove the 11 transmission side cover bolts (3) or Studs (4) (model dependant).
    21. CAUTION: Pry on the corner of the case side cover near the locating dowel pins (45), to prevent damage to the sealing surfaces.
  21. Remove the transmission side cover (1).
  22. Remove the two side cover gaskets (5 and 6) and the side cover to driven support thrust washer (7). They may remain with the side cover. Only replace if necessary.
scientia non olet · About LEMON Manuals