LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the parking brake and place the control assembly in Neutral. The transaxle manual shaft must be in the Neutral position prior to installing the range switch.
    2. Fig 1: Identifying Shift Control Cable, Lever & Electrical Connector At Transaxle Range (TR) Switch
    GM1233683Courtesy of GENERAL MOTORS CORP.
  2. Remove the shift control cable from the transaxle range switch lever.
    3. Fig 2: Identifying Transaxle Range (PNP) Switch Lever
    GM1233687Courtesy of GENERAL MOTORS CORP.
    WARNING: Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.
  3. Remove the transaxle range switch lever nut and lever.
scientia non olet · About LEMON Manuals