Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Lubricate a new O-ring with DEXRON III transmission fluid.
Install the new O-ring.

Fig 1: Identifying VSS Retainer

Courtesy of GENERAL MOTORS CORP.

Install the VSS assembly.
Install the VSS retainer.

Fig 2: View Of VSS Retainer Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the VSS retainer bolt.
Tighten: Tighten the bolt to 12 N.m (8 lb ft).

Fig 3: Connecting VSS Connector To VSS

Courtesy of GENERAL MOTORS CORP.

Connect the VSS connector to the VSS.
Lower the vehicle.