LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Manual Transmission - M86) >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Transaxle Mount Through Bolt
    GM851620Courtesy of GENERAL MOTORS CORP.
  1. Install the rear transaxle mount and heat shield. Hand start the bolts.
    2. CAUTION: Refer to Fastener Caution .
  2. Tighten the rear transaxle mount to frame bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

    3. NOTE: Rotate the rear transaxle mount heat shield clockwise until the tab is seated on the mount bracket.
  3. Hand start the rear transaxle mount through bolt.
    4. NOTE: The front and rear transmission mounts must be allowed to settle with the through bolts loosened.
  4. Loosen the front trans mount through bolt.
  5. Tighten the transmission mount through bolts in the following order:

    Tighten: 

    1. Tighten the rear bolt to 100 N.m (74 lb ft ).
    2. Tighten the front bolt to 100 N.m (74 lb ft ).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals