LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Manual Transmission - M86) >> Repair Instructions - On Vehicle >> Transmission Rear Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Sealant To Rear Cover
    GM514887Courtesy of GENERAL MOTORS CORP.
  1. Install sealant to the rear cover. For the sealant part number, refer to Adhesives, Fluids, Lubricants, and Sealers .
    2. Fig 2: View Of Rear Cover
    GM513914Courtesy of GENERAL MOTORS CORP.
    NOTE: The oil guide only installs in one direction. Ensure the oil guide is completely seated in the gear shafts.
  2. Install the oil guide.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the rear cover.

    Tighten:  Tighten the rear cover bolts to 25 N.m (18 lb ft).

  4. Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals