LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Manual Transmission - M86) >> Repair Instructions - On Vehicle >> Transmission Fluid Replacement >> Filling Procedure

Filling Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Fluid Level Check Plugs
    GM857189Courtesy of GENERAL MOTORS CORP.
  1. Clean away all dirt and debris from the transmission fluid fill plug area.
  2. Remove the transmission fluid level check plug.
  3. Fill the transmission with the proper fluid until even with the bottom of the fill plug hole. Refer to Lubrication Specifications  for fluid recommendation.
  4. Install the level check plug.

    Tighten:  Tighten the level check plug to 38 N.m (28 lb ft).

  5. Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals