LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Manual Transmission - M86) >> Repair Instructions - On Vehicle >> Transmission Fluid Replacement >> Draining Procedure

Draining Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation .
    2. Fig 1: Locating Fluid Level Check Plugs
    GM857189Courtesy of GENERAL MOTORS CORP.
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Clean away all dirt and debris from the transmission fluid drain plug area.
  4. Remove the drain plug.
  5. Allow the system to drain.
    6. CAUTION: Refer to Fastener Caution .
  6. Install the transmission fluid drain plug, using pipe sealant on the plug threads.

    Tighten:  Tighten the transmission fluid drain plug to 38 N.m (28 lb ft).

scientia non olet · About LEMON Manuals