LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Manual Transmission - M86) >> Repair Instructions - On Vehicle >> Transmission Fluid Level and Condition Check

Transmission Fluid Level and Condition Check

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation .
    2. NOTE: Inspect the fluid level only when the engine is off. Ensure the vehicle is level. The transaxle must be cold.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Locating Fluid Level Check Plugs
    GM857189Courtesy of GENERAL MOTORS CORP.
  3. Remove the level check plug.
  4. Verify that the fluid is up to the opening.
  5. If no fluid is visible, add fluid until the level check opening begins to leak fluid. Refer to Lubrication Specifications  for fluid recommendations.
    6. CAUTION: Refer to Fastener Caution .
  6. Install the fluid level check plug.

    Tighten:  Tighten the fluid level check plug to 38 N.m (28 lb ft).

  7. Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals