LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Manual Transmission - M86) >> Repair Instructions - On Vehicle >> Shift Control Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Case-To-Shifter Cover Mating Surface
    GM892790Courtesy of GENERAL MOTORS CORP.
    NOTE: Use only the approved sealer for the transmission case to shifter cover mating surface.
  1. Apply sealer P/N 12378516 to the transmission case to shifter cover mating surface.
    2. Fig 2: View Of Shifter And Retaining Bolts
    GM513882Courtesy of GENERAL MOTORS CORP.
  2. Install the shifter.
    3. NOTE: It will be necessary to move the shifter lever when installing and tightening the bolts.
  3. Hand start all the shifter bolts.
    4. CAUTION: Refer to Fastener Caution .
  4. Tighten the Shifter bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  5. Verify that the transmission is still in neutral position.
    6. NOTE: To avoid damage to the shifter guide bolt, hand start the bolt.
  6. Apply P/N 21485278 to the shifter guide bolt and install the shifter guide bolt. Hand tighten only.
  7. Tighten the shifter guide bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    8. Fig 3: View Of Shift Cables, Cable Connections & Shift Cable Bracket
    GM880090Courtesy of GENERAL MOTORS CORP.
  8. Connect the shift cables to the transmission.
  9. Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals