LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Manual Transmission - M86) >> Repair Instructions - On Vehicle >> Front Wheel Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate a new O-ring with transmission fluid. Refer to Lubrication Specifications .
  2. Install the new O-ring.
    3. Fig 1: View Of Vehicle Speed Sensor & Bolt
    GM658863Courtesy of GENERAL MOTORS CORP.
  3. Install the VSS assembly.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the VSS retainer bolt.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

    5. Fig 2: Locating Backup Light Connector & VSS Connector
    GM857190Courtesy of GENERAL MOTORS CORP.
  5. Connect the VSS connector to the VSS (2).
  6. Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals