Circuit/System Verification
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, individually open and close each vehicle door while observing the door ajar indicator/message. The indicator/message should accurately transition between the door ajar and door closed state when each door is opened and closed.
- If the door ajar indicator/message does not properly transition when each door is opened and closed, refer to Door Ajar Indicator Malfunction .
- Open and close the trunk while observing the trunk ajar indicator/message. The indicator/message should accurately transition between the trunk ajar and trunk closed state when the trunk is opened and closed.
- If the trunk ajar indicator/message does not properly transition when the trunk is opened and closed, refer to Trunk Ajar Indicator Malfunction .
- Completely lower the driver door window and close all vehicle doors.
- Ignition OFF, arm the CTD system using the keyless entry system by pressing the transmitter LOCK button twice. Verify the scan tool CTD Status parameter displays Armed.
- If not the specified value, refer to Keyless Entry System Inoperative .
- Without disarming the system, reach in through the open driver window, unlock and open the driver door. Verify the scan tool Content Theft Mode parameter displays Alarm.
- If not the specified value, replace the BCM.
- With the door open, verify the vehicle horn is pulsing and the exterior lamps are flashing.
- If the horn is not pulsing, refer to Horns Malfunction .
- If the exterior lights are not flashing, refer to Turn Signal Lamps and/or Indicators Malfunction .