LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Corvette Z06 >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Anti-Lock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW With TCS & VSES) >> Repair Instructions >> Rear Wheel Speed Sensor Ring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Ring Replacement .
  4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6 Inch axle) or Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) .
  5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
    6. Fig 1: View Of Wheel Speed Sensor Ring, Axle Housing & Removal Tool
    GM889095Courtesy of GENERAL MOTORS CORP.
  6. Remove the axle shaft seal, the bearing and the wheel speed sensor ring from the axle housing using the J 45857  (1) and the J 2619-01  (2).
scientia non olet · About LEMON Manuals