LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Corvette Z06 >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Anti-Lock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW With TCS & VSES) >> Diagnostic Information and Procedures >> DTC C0110 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the EBCM.
  2. Test for less than 1 ohm between the ground circuits listed below and ground:
    • Terminal 38
    • Terminal 13
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground:
    • Terminal 25
    • Terminal 1
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the B+ circuit fuse is open, replace the BPMV.
  4. If all circuits test normal, replace the BPMV and verify DTC does not reset. If the DTC resets replace the EBCM.
scientia non olet · About LEMON Manuals