Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Corvette ZR-1, Trans Mfr CD 6L95M/ME2, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| ZR-1, All | 2.2 | B | ||
| ZR-1, Front or Rear,Both Sides | 1.2 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | 0.2 | B | ||
| One | Includes: Bleed Brakes. | 0.5 | B | |
| Combination Procedure: CALIPER: Overhaul: | ||||
| ZR-1, Front,One | Includes: Bleed Brakes. | 1.3 | B | |
| ZR-1, Rear,One | Includes: Bleed Brakes. | 0.9 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One | Includes: Bleed Brakes. | 0.5 | B | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing or correction plate. | 0.2 | B | |
| Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots. | ||||
| Each Additional | 0.3 | B | ||
| One | 0.5 | B | ||
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Both | Includes: R&I Wheel Hub Assembly. | 3.3 | B | |
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| ZR-1, Front,Hub Assembly,One Side | 1.5 | B | ||
| ZR-1, Rear,Hub Assembly,One Side | 1.7 | B | ||