Hydraulic Hose: Service and Repair

Hydraulic Clutch Hose/Pipe Replacement

Removal Procedure





1. Remove the clutch actuator cylinder. Refer to Clutch Actuator Cylinder Replacement Service and Repair.

2. Use a small drift or punch to remove the roll-pin retaining the hydraulic hose to the actuator cylinder.





3. Remove the hydraulic hose from the actuator cylinder.

4. Drain off the excess fluid from the actuator cylinder into a container.

Installation Procedure





1. Install the new clutch actuator cylinder hose to the clutch actuator cylinder.

Check the new O-ring seal for proper placement on the actuator cylinder hose.





2. Install the actuator cylinder hose roll-pin retainer using a small drift or punch.

3. Rotate the actuator cylinder hose to ensure freedom of movement.

4. Install the clutch actuator cylinder. Refer to Clutch Actuator Cylinder Replacement Service and Repair.