Parking Brake Warning Switch: Service and Repair

Parking Brake Indicator Switch Replacement

Removal Procedure




1. Remove the knee bolster trim panel. Refer to Knee Bolster Replacement Knee Bolster Replacement.




2. Remove the electrical connector.




3. Remove the park brake warning lamp switch mounting bolt.




4. Remove the park brake warning lamp switch from the vehicle.

Installation Procedure




1. Install the park brake warning lamp switch.





Caution: Refer to Fastener Caution Fastener Caution.

2. Install the park brake warning lamp switch mounting bolt and tighten to 4 Nm (35 lb in).




3. Install the electrical connector.




4. Install the knee bolster trim panel. Refer to Knee Bolster Replacement Knee Bolster Replacement.