LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Camaro LS, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Window Motors & Regulators >> Fixed And MOVEABLE Windows >> Repair Instructions >> Quarter Window Replacement - Brazil >> Removal Procedure

Removal Procedure

    WARNING:

    Refer to Cracked Window Warning .

    NOTE:

    Before cutting out a quarter window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

  1. Remove the quarter window from the auto-adhesive as follows:
    • Leave a base of auto-auto-adhesive approximately 2 mm (0.078 in) on the pinch-weld flange.
    • The only suitable lubrication is clear water.
    • Use S-0201964  Bonded, Glass Removing Device.
  2. Protect the following parts from broken glass, seats and carpeting.
  3. Start the cut between the quarter and the "B" pillar.
    1. Do this from inside the vehicle, insert the tool S-0201964  Bonded, Glass Removing Device (1) between the quarter and the "B" pillar, thus perforating the adhesive.
    2. Move the cutting wire along the outside edge of the window.
    3. Remove the tool S-0201964  Bonded, Glass Removing Device.
    4. Do this from inside the vehicle, install the cutting wire special tool S-0201964  Bonded, Glass Removing Device (1).
    5. Do this from outside the vehicle, install the cutting wire special tool S-0201964  Bonded, Glass Removing Device (2).
    6. With an assistant, use the special tool S-0201964  Bonded, Glass Removing Device (1) to hold the cutting wire, pull it starting from the outside, back and forth releasing the window from the adhesive.
    7. While cutting the window reposition the cutting wire and special tools, so as to cut the adhesive along the window completely.
    4. Fig 1: Quarter Modular Window
    GM2174939Courtesy of GENERAL MOTORS COMPANY
  4. Remove the window (1) from the vehicle.
scientia non olet · About LEMON Manuals