Shock Absorber and Spring Removal and Installation

Fig 1: Shock Absorber And Spring Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation . Disconnect the outer tie rod from the steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
1	Shock Absorber Module Bolt (Qty: 2) CAUTION: Do not use air powered tools in order to disassemble or assemble any vehicle component. Bolt torques are vital to diagnosis. You can detect bolt torques only when using hand tools. Improper bolt torques can contribute to vehicle repair problems. CAUTION: Refer to Fastener Caution . Procedure Support the lower control arm. Disconnect the electronic suspension control electrical connector. Tighten 50 N.m (37 lb ft)
2	Shock Absorber Module Nut (Qty: 3) Tighten 50 N.m (37 lb ft)
3	Shock Absorber Module Procedure If you are removing the shock module in order to service the components, refer to appropriate procedure in this information. For the proper disposal procedure of the shock absorber, refer to Shock Absorber Disposal .