Heater Inlet Hose Replacement (Pump to Heater Core-HP2)

Fig 1: Heater Inlet Hose (Pump to Heater Core-HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) . Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement . Remove the air cleaner. Refer to Air Cleaner Assembly Replacement . Remove the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
1	Heater Inlet Hose Quick Disconnect Procedure Squeeze the plastic retainer release tabs and pull the connection apart. The joint should audibly click upon reassembly and the technician should pull back on the joint to ensure it's engaged properly.
2	Heater Inlet Hose Clamp Procedure Using J 38185 reposition the heater hose clamps at pump. Special Tools J 38185 Hose Clamp Pliers
3	Heater Inlet Hose