Transfer Case Rear Case Half Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Transfer Case Rear Case Half

GM1849370

Courtesy of GENERAL MOTORS CORP.

Transfer Case Rear Case Half Installation

Callout	Component Name
1	Transfer Case Front Half CAUTION: Apply the proper amount of sealant to the flange when assembling the transfer case. Excessive amounts of sealant can plug the oil pump screen, resulting in internal component failure. Procedure Ensure both sealing surfaces of the front and rear case halves are free of dirt, oil and cleaning solvent. Apply a 2 mm (0.078 in) bead of sealant to the front case half. Use sealer GM P/N 88861417/12378521 (Canadian P/N 88861418), or equivalent.
2	Transfer Case Rear Case Half Ensure the transfer case rear output shaft outer retaining ring is in place and aligned prior to mating case halves. Use snap ring pliers to open the transfer case rear output shaft outer retaining ring for the transfer case rear output shaft rear bearing assembly. Insert a rubber coated screwdriver into the speed sensor hole and lift up on the reluctor wheel to engage the retaining ring with the rear bearing assembly.
3	Transfer Case Bracket
4	Transfer Case Bolt (Qty: 17) CAUTION: Refer to Fastener Caution . TIP: Tighten bolts by hand, do not use an air gun. Tighten 25 N.m (18 lb ft)