LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Suburban C2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Transfer Case - Mp 3010-NP0) >> Diagnostic Information and Procedures >> DTC P2160 or P2161 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Measure the resistance between the VSS high signal circuit and the VSS low signal circuit. The resistance should be between 1, 420-2, 140 ohms.
    • If the value is greater than 2, 140 ohms, test the VSS high signal circuit and the VSS low signal circuit for an open.
    • If the value is less than 1, 420 ohms, test the VSS high signal and the VSS low signal circuits for a shorted together condition.
  2. Measure the resistance of the VSS high signal circuit to ground. The resistance should be greater than 10M ohms.
    • If the value is less than 10M ohms, repair the short to ground.
  3. Measure the resistance between the VSS low signal circuit and ground. The resistance should be greater than 10M ohms.
    • If the value is less than 10M ohms, repair the short to ground.
  4. Reconnect the ECM connector. Disconnect the VSS connector. Ignition ON, test the VSS high signal circuit for a short to voltage.
    • If all circuits/connections test normal, test or replace the VSS.
  5. If all previous steps for circuit checking and VSS replacement have been made and all component testing has been performed and the condition persists replace the ECM.
scientia non olet · About LEMON Manuals