Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Key ON, engine ON. Let engine run for at least 1 minute.
- Key OFF for at least 30 seconds to allow for the complete shutdown of the TCCM.
- Key ON, engine OFF.
- Verify that DTC C0387 is not set.
- If DTC C0387 is set, diagnose it first.
- Verify that DTC C0569 is not set.
- If DTC C0569 is set, perform the ATC motor learn procedure. Refer to Transfer Case High/Low Clutch Reset .