LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Suburban C2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Transfer Case - Mp 3010-NP0) >> Diagnostic Information and Procedures >> DTC C0392 >> Transfer Case Two/Four Wheel Drive Actuator Position Sensor/Rotational Position Sensor (RPS)

Transfer Case Two/Four Wheel Drive Actuator Position Sensor/Rotational Position Sensor (RPS)

WARNING: This page is about a different variant/trim than selected.
  1. Key OFF. Disconnect the X1 connector at the RPS.
  2. Remove the RPS from the transfer case.
  3. Connect the RPS.
  4. While monitoring the Rotational Position Sensor parameter in the Data Display section of the scan tool, rotate the center locating tab of the RPS. The Rotational Position Sensor parameter reading should sweep between -146 and +204 degrees.
    • If the RPS does not function as explained, replace the RPS.
scientia non olet · About LEMON Manuals