Rear Output Shaft Assembly Disassemble

WARNING: This page is about a different variant/trim than selected.

Fig 1: Rear Output Shaft Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Transfer Case Rear Output Shaft Rear Bearing Retaining Ring
2	Transfer Case Rear Output Shaft Rear Bearing Assembly TIP: Use an arbor press or suitable puller to remove the bearing from the rear output shaft.
3	Transfer Case Rear Output Shaft Rear Bearing Retaining Ring - Present on Non-Hybrid Applications Only
4	Transfer Case Rear Output Shaft Speed Reluctor Wheel
5	Transfer Case Oil Pump Assembly
6	Transfer Case Front Output Shaft Drive Sprocket Retaining Ring
7	Transfer Case Front Output Shaft Drive Sprocket Spacer - Rear
8	Transfer Case Front Output Shaft Drive Sprocket
9	Transfer Case Four Wheel Drive Clutch Housing Retaining Ring
10	Transfer Case Four Wheel Drive Clutch Housing
11	Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly (Qty: 2) TIP: Only remove the bearing if faulty. Refer to Drive Chain, Drive Sprocket, and Driven Sprocket Cleaning and Inspection .
12	Transfer Case Front Output Shaft Drive Sprocket Spacer - Front
13	Transfer Case Two/Four Wheel Drive Clutch Retaining Ring
14	Transfer Case Four Wheel Drive Clutch Shim
15	Transfer Case Four Wheel Drive Clutch Hub
16	Transfer Case Four Wheel Drive Clutch Pressure - Friction - Plate (Qty: 8)
17	Transfer Case Four Wheel Drive Clutch Pressure - Steel - Plate (Qty: 7)
18	Transfer Case Four Wheel Drive Clutch Pressure Plate Spring (Qty: 4)
19	Transfer Case Four Wheel Drive Clutch Pressure - Apply - Plate
20	Transfer Case Control Actuator Lever Washer
21	Transfer Case Control Actuator Lever Thrust Bearing Assembly
22	Transfer Case Control Actuator Lever Assembly
23	Transfer Case Control Actuator Lever Ball (Qty: 3)
24	Transfer Case Control Actuator Lever Bearing Assembly
25	Transfer Case Control Lever
26	Transfer Case Control Actuator Lever Thrust Bearing Assembly
27	Transfer Case Rear Output Shaft