Rear Output Shaft Bushing Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Rear Output Shaft Bushing

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Ensure the bushing is installed squarely into the bushing bore.
1	Transfer Case Rear Output Shaft Bushing TIP: Press the bushing until the tool bottoms on the rear case half. Special Tools GE-8092 Driver Handle Driver Handle DT-48022 Output Bushing Installer DT-48209 Bushing Remover For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Preliminary Procedure
Ensure the bushing is installed squarely into the bushing bore.

Transfer Case Rear Output Shaft Bushing
TIP: Press the bushing until the tool bottoms on the rear case half.

Special Tools

For equivalent regional tools, refer to Special Tools .