Torque Dampener Housing and Fluid Pump Cover Installation

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Torque Dampener Housing And Fluid Pump Cover Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	A/Trans Torque Dampener Housing Gasket TIP: Do not reuse the gasket. Replace with a NEW gasket.
2	A/Trans Torque Dampener (w/Fluid Pump) Housing Assembly
3	A/Trans Fluid Pump Cover Bolt M8 x 1.25 x 25 (Qty: 12) CAUTION: Refer to Fastener Caution . Procedure: Tighten in the sequence shown. Tighten 24-29 N.m (17.70-21.38 lb ft)