Torque Dampener Housing and Fluid Pump Cover Assemble

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Torque Dampener Housing And Fluid Pump Cover

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure If installing a NEW pump rotor and slide into the torque dampener housing or a NEW torque dampener housing, ensure to properly select the correct rotor and slide before performing this procedure. Refer to Fluid Pump Selective Measurement , and Fluid Pump Selective Specifications .
1	Pump Slide Fluid Seal Ring
2	A/Trans Fluid Pump Slide O-Ring Seal
3	A/Trans Fluid Pump Slide Pivot Pin
4	A/Trans Fluid Pump Slide Seal Support TIP: The seal support is circular. The seal is rectangular.
5	A/Trans Fluid Pump Slide Seal
6	A/Trans Fluid Pump Slide
7	A/Trans Fluid Pump Slide Outer Spring
8	A/Trans Fluid Pump Vane Ring
9	A/Trans Fluid Pump Rotor Guide CAUTION: Align the rotor guide tabs to the notches on the bottom of the rotor. Failure to do so may cause transmission damage.
10	A/Trans Fluid Pump Rotor
11	A/Trans Fluid Pump Vanes (Qty: 13)
12	A/Trans Fluid Pump Slide O-Ring Seal