Sun Gear Carrier and Hybrid Direct, 2-3-4 Clutch Housing Installation
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Sun Gear Carrier and Hybrid Direct, 2-3-4 Clutch Housing Installation
| Callout | Component Name |
|---|---|
| 1 | Hybrid Direct, 2-3-4 Clutch Housing Thrust Bearing Assembly |
| 2 | Hybrid Direct, 2-3-4 Clutch Housing Assembly |
| 3 | Output Shaft Assembly |
| 4 | Output Shaft Retaining Ring TIP: Inspect the retainer ring and ensure it is seated properly. It is not necessary to remove the retainer ring unless it is damaged, in which case it will need to be replaced. |
| 5 | Output Shaft Thrust Bearing Assembly |
| 6 | Hybrid Direct, 2-3-4 Clutch Hub |
| 7 | Internal Gear Thrust Bearing Assembly - 2nd Position |
| 8 | Sun Gear Carrier Assembly - 3rd Position |
| 9 | Internal Gear Thrust Washer - Steel - 3rd Position |
| 10 | Internal Gear Thrust Washer - Plastic - 3rd Position |
| 11 | Internal Gear - 3rd Position |