LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Suburban C2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1751 (Engine Controls And Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister Purge Solenoid
    GM1706144Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge solenoid.
  2. Install the EVAP canister purge solenoid to the fuel rail and engage the retainer.
    3. Fig 2: Engine Wiring Harness Electrical Connectors, EVAP Purge Solenoid And MAP Sensor
    GM1960247Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (2) to the EVAP canister purge solenoid (3).
  4. Connect the chassis EVAP line quick connect fitting to the EVAP canister purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: EVAP Line And Canister Purge Solenoid
    GM1706143Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP line quick connect fitting to the EVAP canister purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals