Front Fender Replacement - Left Side

Fig 1: Front Fender - Left Side

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the headlamp. Refer to Headlamp Replacement (Cadillac Escalade) , Headlamp Replacement (Tahoe, Avalanche) , Headlamp Replacement (Chevrolet Tahoe Two-mode Hybrid) , Headlamp Replacement (Escalade PLATINUM) , Headlamp Replacement (Non HID) , Headlamp Replacement (Yukon) , Headlamp Replacement (GMC Yukon Two-mode Hybrid) . Remove the radiator support diagonal brace. Refer to Radiator Support Diagonal Brace Replacement . Remove the upper rear fender bracket. Refer to Front Fender Rear Upper Bracket Replacement . Remove the auxiliary battery tray. Refer to Auxiliary Battery Tray Replacement Remove the left hood hinge. Refer to Hood Hinge Replacement . Remove the left hood open assist spring. Refer to Hood Open Assist Spring Replacement . Remove the underhood electrical center/junction block. Refer to Underhood Electrical Center or Junction Block Replacement . Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
1	Fender Mounting Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 25 N.m (18 lb ft)
2	Fender Mounting Bolt (Qty: 3) Tighten 30 N.m (22 lb ft) Procedure Apply threadlock compound to the bolts.
3	Fender Mounting Clip (Qty: 3)
4	Fender Mounting Nut (Qty: 2) Tighten 25 N.m (18 lb ft)
5	Fender Assembly TIP: Transfer any necessary additional parts as needed.