LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Suburban C2500 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Cargo Box Stowage Box Lid Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Cargo Stowage Box
    GM1708946Courtesy of GENERAL MOTORS CORP.
  1. Position the cargo box stowage lid (3) to the vehicle.
    2. NOTE:

    Ensure that the feather edge is properly sealed to the glass and side panels.

  2. Install the cargo box water run channel.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the bolts to the cargo box stowage lid (1) and tighten to 9 N.m (80 lb in).
  4. Install the bolt inside the cargo box stowage lid assembly (2) and tighten to 9 N.m (80 lb in).
  5. Install the cargo box bridge side inner panel. Refer to Cargo Box Bridge Side Inner Panel Replacement (Escalade EXT) , Cargo Box Bridge Side Inner Panel Replacement (Avalanche) .
  6. Install the assist handle. Refer to Cargo Box Stowage Box Handle Replacement (Avalanche) .
  7. Install the cargo box cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
  8. Close the endgate.
scientia non olet · About LEMON Manuals