Radio Speaker Amplifier Replacement (Cadillac)

Fig 1: Radio Speaker Amplifier Assembly And Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the floor console bezel. Refer to Floor Console Bezel Replacement (Except Cadillac) , Floor Console Bezel Replacement (Cadillac) . Remove the front floor console side trim front panel - Left. Refer to Front Floor Console Side Trim Front Panel Replacement - Left Side (Cadillac) . Remove the front floor console side trim front panel - Right. Refer to Front Floor Console Side Trim Front Panel Replacement - Right Side (Cadillac) .
1	Front Floor Console Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
2	Front Floor Console Rear Screw (Qty: 2) TIP: Open the rear cupholder to access the screws. Tighten 2 N.m (18 lb in)
3	Front Floor Console Lower Screw (Qty: 4) Procedure Move the seats forward or rearward to access the screws as needed. Rotate the upper portion of the console assembly rearward to access the amplifier. Tighten 9 N.m (80 lb in)
4	Amplifier Screw (Qty: 4) Tighten 9 N.m (80 lb in)
5	Radio Speaker Amplifier Assembly Procedure Disconnect the electrical connectors. For programming and set up, refer to Control Module References .