LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 3 Of 5)) >> Off-Vehicle Repair Instructions - Part 2 >> Intake Manifold Disassemble >> Upper Intake Manifold Disassemble Procedure

Upper Intake Manifold Disassemble Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Rail Support Bracket Bolt
    GM1531030Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel rail support bracket bolt.
  2. Remove the fuel rail support bracket.
    3. Fig 2: Locating Throttle Body Bolts
    GM1408449Courtesy of GENERAL MOTORS CORP.
  3. Remove the throttle body bolts.
  4. Remove the throttle body.
  5. Remove and discard the throttle body gasket.
    6. Fig 3: Identifying Barometric Pressure (BARO) Sensor Bolt
    GM1408451Courtesy of GENERAL MOTORS CORP.
  6. Remove the barometric pressure (BARO) sensor bolt.
  7. Remove the BARO sensor.
    8. Fig 4: Intake Manifold Opening Cover Bolts
    GM1531033Courtesy of GENERAL MOTORS CORP.
  8. Remove the intake manifold opening cover bolts.
  9. Remove the intake manifold opening cover.
scientia non olet · About LEMON Manuals