LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the case side cover. Refer to Control Valve Body Cover Replacement .
    2. Fig 1: Wiring Harness & Fluid Temperature Sensor
    GM48209Courtesy of GENERAL MOTORS CORP.
  2. Use a small flat-bladed tool in order to remove the wiring harness from the solenoid valve (315A, 315B, 322, 334 and/or 440), TFP manual valve position switch (395) and the temperature sensor (391).
    3. Fig 2: View Of Transmission Internal Wiring Harness
    GM48210Courtesy of GENERAL MOTORS CORP.
  3. Remove the wiring harness (224).
scientia non olet · About LEMON Manuals