LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left tire and wheel assembly.
  3. Remove the left engine splash shield. Refer to Engine Splash Shield Replacement (Right) or Engine Splash Shield Replacement (Left) .
  4. Position a transmission jack under the transaxle.
    5. Fig 1: View Of Transmission/Transaxle Mount
    GM630964Courtesy of GENERAL MOTORS CORP.
  5. Remove the transaxle mount upper nuts from the transaxle bracket.
  6. Carefully raise the transaxle assembly.
    7. Fig 2: Transaxle Mount
    GM462438Courtesy of GENERAL MOTORS CORP.
  7. Remove the transaxle mount lower nuts from the frame.
  8. Remove the transaxle mount from the frame.
scientia non olet · About LEMON Manuals