LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transaxle Mount
    GM462438Courtesy of GENERAL MOTORS CORP.
  1. Position the transaxle mount to the frame.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the transaxle mount lower nuts to the frame and tighten to 52 N.m (38 lb ft).
  3. Lower the transaxle so the transaxle mount studs install into the transaxle bracket.
    4. Fig 2: View Of Transmission/Transaxle Mount
    GM630964Courtesy of GENERAL MOTORS CORP.
  4. Install the transaxle mount upper nuts to the transaxle mount and tighten to 52 N.m (38 lb ft).
  5. Remove the transmission jack from the transaxle.
  6. Install the left engine splash shield. Refer to Engine Splash Shield Replacement (Right) or Engine Splash Shield Replacement (Left) .
  7. Install the left wheel and tire assembly.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals