LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Bracket Replacement - Left Side (LZE or LGD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the left engine splash shield. Refer to Engine Splash Shield Replacement (Right) or Engine Splash Shield Replacement (Left) .
  4. Support the transaxle.
    5. Fig 1: View Of Transmission/Transaxle Mount
    GM630964Courtesy of GENERAL MOTORS CORP.
  5. Remove the transaxle bracket to transaxle mount upper nuts.
    6. Fig 2: View Of Transaxle Mount Bracket And Bolts
    GM161246Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts which secure the transaxle bracket to the transaxle.
  7. Remove the transaxle bracket.
scientia non olet · About LEMON Manuals