LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Bracket Replacement - Left Side (LZE or LGD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Transaxle Mount Bracket And Bolts
    GM161246Courtesy of GENERAL MOTORS CORP.
  1. Position the transaxle bracket to the transaxle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the transaxle bracket bolts and tighten to 95 N.m (70 lb ft).
  3. Remove the support from the transaxle.
    4. Fig 2: View Of Transmission/Transaxle Mount
    GM630964Courtesy of GENERAL MOTORS CORP.
  4. Install the upper nuts which secure the transaxle bracket to the transaxle mount. Tighten the upper nuts to 52 N.m (38 lb ft).
  5. Install the left engine splash shield. Refer to Engine Splash Shield Replacement (Right) or Engine Splash Shield Replacement (Left) .
  6. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals