LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Connector Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Transaxle Oil Cooler Fittings
    GM627406Courtesy of GENERAL MOTORS CORP.
    CAUTION: Allow sufficient clearance around the transaxle oil cooler pipes and around the hoses to prevent damage or wear which may cause fluid loss.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Position a drain pan under the vehicle.
  3. Remove the transaxle oil cooler hoses from the transaxle oil cooler fittings. Refer to Transmission Fluid Cooler Hose/Pipe Replacement .
  4. Remove the transaxle oil cooler fittings (28, 29) from the transaxle.
scientia non olet · About LEMON Manuals