LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the console trim plate. Refer to Front Floor Console Replacement .
  2. Remove the console wiring harness.
    3. Fig 1: Console Shift Control Wiring Harness
    GM161196Courtesy of GENERAL MOTORS CORP.
  3. Remove the console shift control wiring harness.
  4. Remove the automatic transaxle range selector cable. Refer to Range Selector Lever Cable Replacement .
  5. Disconnect the light bulb and the retainer from the shiftier.
    6. Fig 2: Console Shift Control Assembly
    GM161200Courtesy of GENERAL MOTORS CORP.
  6. Remove the console shift control retaining nuts.
  7. Remove the console shift control assembly from the vehicle.
scientia non olet · About LEMON Manuals