LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Console Shift Control Assembly
    GM161200Courtesy of GENERAL MOTORS CORP.
  1. Install the console shift control into the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the console shift control retaining nuts and tighten to 20 N.m (15 lb ft).
  3. Install the automatic transaxle range selector cable. Refer to Range Selector Lever Cable Replacement .
    4. Fig 2: Console Shift Control Wiring Harness
    GM161196Courtesy of GENERAL MOTORS CORP.
  4. Install the console shift control wiring harness.
  5. Install the console wiring harness.
  6. Install the console trim plate. Refer to Front Floor Console Replacement .
scientia non olet · About LEMON Manuals