LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Torque Converter Bolt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Torque Converter Covers
    GM631009Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the torque converter cover bolts.
  3. Remove the torque converter covers.
    4. Fig 2: View Of Flywheel And Flywheel Holder (J 37096)
    GM309963Courtesy of GENERAL MOTORS CORP.
  4. Install the J 37096  in order to gain access to the torque converter bolts and to prevent the flywheel from turning.
    5. Fig 3: Identifying Flywheel To Torque Converter Bolts
    GM160984Courtesy of GENERAL MOTORS CORP.
  5. Remove the flywheel to torque converter bolts.
scientia non olet · About LEMON Manuals