Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Flywheel And Flywheel Holder (J 37096)

Courtesy of GENERAL MOTORS CORP.

Install the J 37096 in order to gain access to the torque converter bolts and to prevent the flywheel from turning.

Fig 2: Identifying Flywheel To Torque Converter Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the flywheel to torque converter bolts.
Tighten: Tighten the bolts to 63 N.m (46 lb ft).

Fig 3: Identifying Torque Converter Covers

Courtesy of GENERAL MOTORS CORP.

Install the torque converter covers.
Install the torque converter cover bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in)
Lower the vehicle.