LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Reverse Servo Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner outlet duct. Refer to the following:
    2. Fig 1: Identifying Reverse Servo Cover And Snap Ring
    GM48166Courtesy of GENERAL MOTORS CORP.
  2. Remove the exhaust crossover pipe. Refer to Exhaust Crossover Pipe Replacement (LGD/LZE) .
  3. Depress the reverse servo cover (40).
  4. Remove the snap ring (39).
    5. Fig 2: O-Ring Seal And Reverse Servo Cover
    GM48171Courtesy of GENERAL MOTORS CORP.
  5. Pull the O-ring seal (41) out through the slot in the case.
  6. Use side cutting pliers in order to cut the servo cover O-ring seal (41).
  7. Depress the reverse servo cover (40), grasp one end of the cut seal (41) and pull the seal (41) out of the servo cover (40).
    8. Fig 3: Identifying Reverse Servo Assembly Components
    GM48173Courtesy of GENERAL MOTORS CORP.
  8. Remove the reverse servo cover (40).
  9. Remove the servo assembly (42-48).
  10. Remove the servo spring (49).
scientia non olet · About LEMON Manuals