LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Transaxle Oil Pan And Gasket
    GM164804Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pan gasket (25).
  2. Install the oil pan (24).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the oil pan bolts (23).

    Tighten:  Tighten the bolts to 14 N.m (10 lb ft).

  4. Lower the vehicle.
    5. CAUTION: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.
  5. Fill the transaxle. Refer to Fluid Capacity Specifications .
  6. Place the gear selector in the PARK position.
  7. Start the engine.
  8. Run the engine at a slow idle. Do NOT race the engine.
  9. Adjust the fluid level.
  10. Inspect for leaks.
scientia non olet · About LEMON Manuals